Flush Mount Ceiling Kit Installing the Recessed Camera Mount | en 5
Bosch Security Systems, Inc. Mounting Guide F.01U.126.944 | 1.0 | 2009.04
2.1 Installing the VDA-NWDSKT Bracket
The VDA-NWDSKT is a support bracket for the VDA-NWDFMT
Flush Mount Ceiling kit. Use this bracket to add support to a
ceiling tile.
Note: The weight of the VDA-NWDSKT is 1.12 kg (2.46 lb).
1. Remove the ceiling tile.
2. Determine the proper width of the VDA-NWDSKT so that
the side tabs rest against the ceiling T-rails.
3. Align the two panels of the VDA-NWDSKT to the proper
width and secure with the four Phillips head screws
(supplied).
Figure 2.1 VDA-NWDSKT Support Kit
4. Use the VDA-NWDSKT as a template to mark the top of the
ceiling tile; then cut the tile along the template mark.
5. Replace the ceiling tile and place the VDA-NWDSKT on top
of the tile.
