AutoDome 800 Series HD PTZ Camera Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 29
Bosch Security Systems, Inc. Installation Manual F.01U.273.797 | 5.0 | 2012.08
Figure 2.14 Mounting Plate - Inside Detail
4. Connect the incoming 24 VAC power wires to the 5-pin, 24 VAC Power In mating
connector (supplied with the Mounting Plate kit) for the Dome and for the Heater.
5. Attach the grounding spade from the 5-pin mating connector (item 1, Figure 2.14) to the
other spade terminal inside the mounting plate.
6. Attach the 5-pin Power In mating connector to the 24 VAC Power cable (cable 2)
connected to the pendant.
7. Connect the incoming RJ45 video connector, installed previously, to the Ethernet cable
(cable 5). Refer to Section 4 Cable and Wire Standards, page 51, for detailed wire and
connection information.
8. Connect the outgoing alarm wires to the flying leads coming from the 4-pin Alarm
Outputs cable (cable 6).
9. Connect the incoming alarms wires to the flying leads coming from the 6-pin Alarm Inputs
cable (cable 7).
10. Connect the incoming Audio In wires to the 6-pin mating connector supplied with the
VG4-A-ARMPLATE kit. Ensure that the 100 Ω resistor has been removed between C-
(Audio -) and the C+ (Audio +) terminals.
Refer to Section 4 Cable and Wire Standards, page 51, for detailed wire and connection
information.
11. Attach the 6-pin Audio In mating connector to the Audio In (cable 8) cable.
Ref. Description
1 Grounding lug with two spade terminals
2 Earth ground lug with crimp ring terminal
3 Wire input conduit holes
