58 en | Configuration Using a Web Browser VideoJet X10
V3.0 | 2007.09 Installation and Operating Manual Bosch Security Systems
5.19.1 Standard profile
From this field, you can select the encoder profile to be used for continuous recording (see
Section 5.11 Encoder Profile, page 38).
5.19.2 Encoder
Here you can select the data stream to be used for the recording.
5.19.3 Alarm track recording
X Click the checkbox to activate alarm track recording. The pre-alarm time is automatically
displayed for information.
5.19.4 Post-alarm time
You can select the required post-alarm time from the list field.
5.19.5 Post-alarm profile
You can select the encoder profile to be used for recording during the post-alarm time (see
Section 5.11 Encoder Profile, page 38).
The Standard profile option adopts the selection for continuous recordings at the top of the
page.
5.19.6 Alarm input / Motion alarm / Video loss alarm
Here you can select the alarm sensor that is to trigger a recording.
i
NOTICE!
The recording profile can deviate from the standard setting Active profile and is only used
during an active recording.
i
NOTICE!
This parameter is active only if alarm tracks have been configured (see Section 5.18.8 Number
of alarm tracks, page 55).
i
NOTICE!
The motion alarm is configured and activated on the VCA page (see Section 5.23 VCA,
page 65).
The alarm inputs are configured and activated on the Alarm sources page (see
Section 5.21 Alarm Sources, page 61).
The numbering of the checkboxes for the alarm inputs corresponds to the labeling of the
alarm inputs on the VideoJet X10.
