22
Specify the IP Address Settings
An IP address must be specied in order to enable communication between the machine and computer.
It is recommended that the network administrator perform the following procedures.
Before performing the following procedure, make sure that the machine is turned on and connected to a network.
This machine is set by default to automatically draw an IP address using DHCP. If your network server or router is congured to provide a
DHCP address, all you need to do is connect a network cable and turn on the machine. The machine will draw an IP address automatically.
This machine also supports automatic IP addresses using BOOTP and RARP protocols. If you use these protocols, select [DHCP] at step 7 of
the following procedures.
This machine supports IPv6. (See Chapter 6, “Network,” in the Reference Guide )
–
–
–
–
–
1 Press
(Additional Functions).
2 Press [System Settings].
3 Press [Network Settings].
4 Press [TCP/IP Settings].
5 Press [IPv4 Settings].
To set up an IPv6 address, see Chapter 6, “Network,” in the
Reference Guide.
