2-- 2
T -343
1
2
3
4
5
8
6
7
REAR OF CHASSIS
ROADSIDE VIEW
CONT AINER FLOOR CROSS I---BEAMS
FORK LIFT POCKET
A
A
VIEW A -
A
1. Angle Assembly, Clamp
2. Wa sher, Spherical, Male
3. Wa sher, Spherical, Female
4. Bolt
5. Wa sher, Spherical, Belleville
6. Roll Pin
7. Nut, Hex, 3/4-10
8. Frame Assembly
Figure 2-2 Typical Generator Set Mounting - Quick Mount
2.2 GENERATOR SET REMOVAL
a. Standard Mount
1. Disconnect power cable to generator (if connected).
2. With fork lift in position and safety chain attached,
slide mounting plates bac k sufficiently to clear chas-
sis.
3. Lower and remove generator.
b. Quick Mount
1. Disconnect power cable to unit (if connected).
2. With fork lift in position and safety chain attached,
loosen mounting bolts, and lift end of bolts out of slot
to orient clamps to open position.
