Page 6SKU 94681
For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
Refer to instructions provided with pump, hoses, and fittings for proper hydraulic
line purging, preparation, and connection procedures.
OPERATING INSTRUCTIONS
WARNING! Before starting work, read and thoroughly understand all warnings and pre-
cautions in this manual and all documentation provided with the hydraulic pump
and hoses used.
Product Overview:
The Auto Body/Frame Repair Kit is designed for bending frames and repairing
dents in vehicle body panels. In most cases, the Push and Pull Hydraulic Rams in
this Kit will only be capable of returning vehicle body and frame parts to their ap-
proximate, original position. Additional work may be required to completely repair
the vehicle part.
The Hydraulic Push Rams:
Included in this Kit are five Hydraulic Push Rams. The larger Push Rams are used
in larger spaces where greater force is needed and where there is sufficient room
to operate. The smaller Push Rams are used in tighter spaces where less force is
required. (See Figure B.)
The Push Rams require a solid, non-movable base directly across from the dam-
aged area and in line with the direction the damaged area needs to be bent. When
positioning the Push Ram, place a block of wood or other material behind the base
of the Push Ram and on the side that is to be bent for protection and to spread the
Push Ram pressure over a greater area. (See Figure B.)
CONNECT TO HYDRAULIC PUMP HOSE
(NOT INCLUDED)
HERE
NON-MOVABLE
AREA
DAMAGED
AREA
WOOD
BLOCK
WOOD
BLOCK
FIGURE B
HYDRAULIC PUSH RAM
The Hydraulic Pull Rams:
Included in this Kit are two Hydraulic Pull Rams. The larger Pull Ram is used in
larger spaces where greater force is needed and where there is sufficient room to
operate. The smaller Pull Ram is used in tighter spaces where less force is required.
(See Figure C, next page.)
1.
2.
1.
