8-26
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)
OL-20861-01
Chapter 8 Configuring Features, Templates, Services, and Users
Configuring Product Specific Configuration Parameters
Configuring Product Specific Configuration Parameters
Cisco Unified Communications Manager Administration allows you to set some product-specific
configuration parameters for Cisco Unified IP Phones in any of the following windows:
• Phone Configuration window (Device > Phone); Product Specific Configuration portion of window
• Common Phone Profile window (Device > Device Settings > Common Phone Profile)
• Enterprise Phone Configuration window (System > Enterprise Phone Configuration)
List of Parameters
You can set the following parameters in any of the three configuration windows listed above:
• Back USB Port (for Cisco Unified IP Phones 9951 and 9971)
• Side USB Port
• Enable/Disable USB Classes
• Bluetooth (for Cisco Unified IP Phones 9951 and 9971)
• Bluetooth Profiles (only for Cisco Unified IP Phones 9951 and 9971)
• WLAN (for Cisco Unified IP Phone 9971 only)
• Settings Access
• Web Access
• Days Display Not Active
• Display on Time
• Display on Duration
• Display Idle Timeout
• Load Server
• RTCP
• Peer Firmware Sharing
• Cisco Discovery Protocol (CDP): Switch Port
• Cisco Discovery Protocol (CDP): PC Port
• Link Layer Discovery Protocol - Media Endpoint Discover (LLDP-MED): Switch Port
• Link Layer Discovery Protocol (LLDP): PC Port
• 802.1x Authentication
• Switch Port Remote Configuration
• PC Port Remote Configuration
• Automatic Port Synchronization
Note Descriptions of these parameters can be found by clicking the “?” button in Cisco Unified
Communications Manager administration.
