A SERVICE OF

logo

ELECTRICAL SYSTEM
Electricity - Electrical flow for frequency converter.
Warranty will be granted only when using the original driver that we supplied.
The electricity connection is done with fittings.
Connect the cables according to their marks:
Power Cable
- marked “power” with a D-type 15 pin plug.
Signal Cable
- marked “signal” with D-type 9 pin plug + plastic socket with 2
pins for thermistor.
Brushes cable
- marked “brushes” with a mini UHP inlet for connecting the
spindle, and 2 plastic pins for connecting the sensors.
The spindle has a unique sensor system built in using 2 brushes attached to the shaft
by air pressure. The coals wear out with time and their life span shortens.
The purpose of the brushes is to transfer the electricity from the control system
through the shaft through the machine-base back to the controller.
This system is able to perform calibration of the height shaft.
27