31
E
Clock setting function
To set the clock, enter the menu and select the “TIME Set”
page.
From this page, if you press switch (1, fig. 8) in position B
“▼” for 3 seconds, you enter clock setting mode.
On entering this function, the message “AM” flashes on the
display; if you press switch (1, fig. 8) in position B “▼”, the
message “PM” flashes on the display; pressing switch
(1, fig. 8) in position B “▼” as second time returns you to
the previous step (if the time is 00:00, when you switch
from AM to PM the time 12:00 will appear);
if you press the switch (1, fig. 8) in position A “▲”, you can
set the hours, which start flashing. Each time you press the
switch in position B “▼”, the count advances cyclically in
steps of 1 hour; if you hold the switch down in position B
“▼”, the count advances cyclically in steps of 1 hour every
second (when the switch is held down continuously, the
hours do not flash);
if you press switch (1, fig. 8) in position A “▲”, you enter
the minutes setting mode and the minute digits will start
flashing. Each time you press the switch in position B “▼”,
the count advances cyclically in steps of 1 minute; if you
hold the switch down in position B “▼”, the count advances
cyclically in steps of 1 minute every second. If the switch is
held pressed in position B “▼” for more than 5 seconds, the
minutes advance by 1 every 100 ms (when the switch is held
in position B “▼” continuously, the seconds do not flash);
if you press the switch in position A “▲”, the system exits
setting mode and displays the newly set time.
flashing
flashing
B
B
B
B
B
A
A
A
A
A
A
setting
flashing
flashing
setting
fig. 23
