Electro-Voice R300 Manual

A SERVICE OF

next previous

10

DETAILED coMponent descriptions

4. ClearScan: Thisfeatureautomatestheprocessofndingaclearchannel.

  a.Toscanfortheclearestchannelinagroup,pressandhold untilCLEARSCAN

appearsinthedisplay,thenreleasethebutton.

  b.Whenthescaniscomplete,thedisplaywillshowtheclearestavailablechannel.

  c.UsetheSYNCbuttontotransferthenewchannelasinstep3.

5.DuringsetupmakesurethemixeroramplierinputusedfortheR300ismutedor

turneddowntoaminimumlevel.

6.Pluganaudiocable(notsupplied)intothe3pinXLRor¼inchoutputoftheR300.

Note:TheXLRconnectoristhepreferredconnectionsincetheoutputisbalancedandwillbe

moreimmunetonoiseforlongerrunsofcablealthougheithercanbeusedwithgoodresults.

Setthebalancedoutputlevelonthebackpanelto12o’clock(midwayintherange)tostartand

adjustlaterifnecessary.Ifthe¼inchunbalancedoutputisused,startwithadjustmentswitchin

the-10dBsetting.

02