30
Troubleshooting
Problem Possible solutions
There is a power failure.
Models with auto-reignition (CG905DWAC)
The gas supply will be cut off, even if a burner is in use.
The cooktop cannot be used if there is a power failure. Wait
until power is restored.
If a control dial is still turned on when the power is restored,
the corresponding ‘Burner On’ indicator will flash rapidly.
Turn the burner off and light it again to resume cooking.
Models with flame failure protection (CG905DWFC, CG604DWFC)
You can still use your cooktop.
Light the burners by holding a match close to the side of the
burner and pressing down then turning the control dial to
HIGH. Wait until the flame is burning evenly before adjusting.
The flame has
accidentally been
extinguished.
Models with auto-reignition (CG905DWAC)
The auto-reignition system will detect this. The ignitors will
spark and relight the burner.
If no flame is detected after about 5 seconds, the gas supply
to the cooktop will be cut off and the ‘Burner On’ indicator
will flash slowly. In this event, turn the burner off and relight
it to resume cooking.
Models with flame failure protection (CG905DWFC, CG604DWFC)
The flame failure protection will automatically cut the gas
supply to the burner off.
Turn the corresponding dial to O (OFF) and do not try to
relight it for at least 1 minute (to allow the gas to disperse).
CG905DWAC models
only: All my ‘Burner On’
indicators are flashing.
Turn all the control dials to O (OFF) and restart.
