A SERVICE OF

logo

4
Note: Services can be located
either side of DishDrawer®.
Cavity preparation
Parts supplied
These marks indicate mounting tab screw locations
Preferred position. If adequate clearance, services hole can be higher to clear toe kick space.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Clamp (1)
Wire clip (2)
Phillips
16 mm
screws (9)
Drain hose
support (1)
Moisture
protection
tape (1)
(to prevent moisture
damage)
Drain hose
joiner (1)
Install
tabs (2)
Prefinished toe kick (1)
White or Black
90
o
10 mm
max. 450 mm
220-240 VAC
min. 9 A
Moisture
protection
tape must
be applied.
min. ø50 mm
DOUBLE MODELS
*
*
*
min. 200 mm
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorized Service Agent or www.fisherpaykel.com. DO NOT extend beyond this limit.
Hexagonal sockets (2)
(Long & Short)