Garmin 19800149402 Manual

next previous

11GPSMAP 4000/5000 Series Installation Instructions



If your boat does not already have an existing NMEA 2000 network installed, you will need to create a basic NMEA 2000 network. For more

information on NMEA 2000, visit www.garmin.com.



1. ConnectthethreeincludedT-connectorstogetherbytheirsides.

2. ConnecttheappropriateterminatorstoeachendofthecombinedT-connectors.

3. WiretheincludedNMEA2000powercabletoa12Vdcpowersourcethroughaswitch.Connecttotheignitionswitchfortheboatifpossible.

4. ConnecttheNMEA2000powercabletothetopofoneoftheT-connectors.

5. RouteandconnecttheincludedNMEA2000dropcablesfromtheGPS19xandfromtheGPSMAP4000/5000serieschartplottertothetops

oftheotherT-connectors.



Drop cables

Male

terminator

T-connectors

Female

terminator

Power cable

Ignition or

in-line switch

12 Vdc battery

Fuse

GPS 19x

antenna

GPSMAP 4000/5000

series chartplotter

NOTES:

• The diagram shows only the NMEA 2000 data connection to the GPSMAP 4000/5000 series chartplotter. The chartplotter must also be

connected to power or it will not function. See page 9.

• One GPS antenna will provide position data for every device on the NMEA 2000 network. Do not connect multiple GPS antennas if you are

using multiple chartplotters.