19
Section 4.0 — System Alarms / Troubleshooting
4.1 Enter Alarm / Troubleshoot Mode
To review the stored alarm codes you must first enter Alarm / Troubleshoot Mode. In order to enter Alarm / Troubleshoot
Mode you must use the main station control head and follow the 4 steps below:
4.2 Retrieving Alarm Count and Alarm Codes
The control head keypad LEDs will alternate between slow blinking and fast blinking, every 4 seconds, to indicate the alarm
count and the alarm codes. The system stores in memory the 16 most recent alarm codes beginning with the latest.
Perform the following steps when you have entered Alarm / Toubleshoot Mode:
Turn
system
OFF
Press Sync & Warm
buttons 3 times
LEDs not
illuminated
NEUTRAL
Out of
NEUTRAL
Out of
NEUTRAL
You may move the handles out of
Neutral in either direction (Ahead
or Astern).
Check to see that the control head
keypad LEDs are NOT illuminated.
This is a visual indication that the
system has been turned OFF.
When the system has been turned
ON the TAKE LED will blink slowly
and a buzzer will be beeping.
After pressing the two buttons, the key-
pad’s 4 LEDs will now begin to alternate
between slow blinking and fast blinking
every 4 seconds.
1
Turn
system
ON
3
Press the
2 center
buttons
on keypad
4
Move
handles
out of
NEUTRAL
2
5.75"
(146 mm)
4.25"
(108 mm)
6.80"
(172mm)
1.5" (38mm)
below panel
5.88" (150mm)
X 3
