Control Processor End
Duetsch 8 pos. Grey
Transmission Harness
Part # 11604-04-xx' For MAN MMDS Box connection
Plugs into the MAN X8 connection
(5'- 30' lengths avail. in 5' increments)
xx' in part number represents length of harness
NOTE: Voltage output will be the same as input to CP
Control Process End
Duetsch 4 pos. Black
Start Interlock Harness
Part # 11602-01 (30' long std.)
NOTE: N.C. circuit between wires for PORT and STBD
Circuit OPENS when system is ON and
is NOT in Neutral position
8 amp max current
Control Processor End
Duetsch 8 pos. Black
Throttle Signal Harness
Part # 11605-M1-xx' For MAN MMDS Box Connections
Plus into the MAN X9 connection
(5'- 30' lengths avail. in 5' increments)
xx' in part number represents length of harness
Control Process End
Duetsch 4 pos. Black
DC Power Harness
Part # 11601-01 (30' long std.)
NOTE: Power wires are 30' long standard
(custom lengths available)
Battery Positive #1
(Red wire)
Battery Positive #2
(Red wire)
Battery Negative
(yellow wire)
(Noise Supression devices)
NOTE : All wires are yellow
with red stripe
Control Process End
Duetsch 12 pos. Grey
CP Enable Switch End
- installer provided switch or
- GMP can provide a waterproof rocker switch
with switch namepate
CP Enable Harness
Part # 11603-12-xx' 12v DC system
Part # 11603-24-xx' 24v DC system
Part # 11603-02-xx' 12 or 24v DC system- pinned in the field
(10' - 100' lengths avail. in 10' increments)
xx' in part number represents length of harness
White
Black
NOTE: DO NOT provide power to this end,
only close the circuit using a N.O. switch
PORT
STBD
NOTE: Each start interlock wire is 30' long standard
(custom lengths available)
MAN MMDS Box End
Harting 16 pos. connector
X9 connection
Connector is the same on both ends
Station Cable
Part # 11600-02-xx' (available 20' - 100' in 20' increments)
Terminating Resistor
Part # 11600-TRF
Two required per system
EEC 3 Control System Harnesses - MAN Engine MMDS with ZF IRM Transmisions
(using gear connections at the X8 MAN MMDS Box)
MAN MMDS Box End
Harting 8 pos. connector
X8 connection
