Hewlett-Packard 2610 Manual

A SERVICE OF

next previous

Quality of Service (QoS): Managing Bandwidth More Effectively

Using QoS Classifiers To Configure QoS for Outbound Traffic

For example, suppose you wanted to assign this set of priorities:

Source-Port DSCP Priority

2 000111 7

5 - 7 000101 5

8, 10 000010 1

1. Determine whether the DSCPs already have priority assignments, which

could indicate use by existing applications. This is not a problem as long

as the configured priorities are acceptable for all applications using the

same DSCP. (Refer to the “Note On Changing a Priority Setting” on page

6-61. Also, a DSCP must have a priority configured before you can assign

any QoS classifiers to use it.)

The DSCPs for this

example have not yet

been assigned an

802.1p priority level.

Figure 6-30. Display the Current Configuration in the DSCP Policy Table

2. Configure the priorities for the DSCPs you want to use.

6-56