A SERVICE OF

logo

Open as PDF
next previous
EN
Removing Assemblies
6-55
Reassembly Steps:
1
Tip the printer back, so that the front faces up.
2
Insert the shaft into the fitting on the right side. Then, angle the
shaft into the other side.
3
Place the bushing on the right end of the shaft, and push until the
tab locks in the indentation in the shaft.
4
Facing the left side of the printer, orient the shaft so that the open
end points away from the solenoid. See Figure 6-44.
5
Depress the solenoid arm, and slide the gear into place. Press it
into the plastic collar until it locks in place.
6
Reinstall the spring on the arm of the gear.
Figure 6-44
Reassembly of Tray 2 Shaft
Item Explanation
A
Direction to Orient Shaft