Optional Network Configuration
(continued)
Configuring Novell NetWare Frame Type
Parameters
Normally, selecting a NetWare frame type is not required. The HP
JetDirect print server automatically selects a NetWare frame type, and
only when this selection is incorrect do you have to set the NetWare
frame type through the printer’s control panel. The NetWare frame
type is displayed on the configuration page.
To manually configure Novell NetWare parameters:
1 Press [Items] until CFG NOVELL=OFF * appears.
2 Press [+] until CFG NOVELL=ON appears.
3 Press [Select*]. CFG NOVELL=YES * appears.
4 Press [Items]. FRAME=AUTO * appears.
5 To configure the Novell NetWare protocol, press [+] to select one of
these frame types:
NOVELL NETWARE FRAME TYPES ON AN HP JETDIRECT PRINT
SERVER
Frame Type Description
AUTO (default) All listed Novell frame types will be allowed.
EN_8023 Limit frame types to IPX over IEEE 802.3 frames. All others will be
counted and discarded.
EN_II Limit frame types to IPX over Ethernet II frames. All others will be
counted and discarded.
EN_8022 Limit frame types to IPX over IEEE 802.2 with Ethernet frames. All
others will be counted and discarded.
EN_SNAP Limit frame types to IPX over SNAP with Ethernet frames. All
others will be counted and discarded.
6 Press [Select*] to save the selection. An asterisk (*) appears.
7 If other protocols will be used, continue with this section. Otherwise,
skip to Step 19.
26 - Getting Started Guide EN
