Optional Network Configuration
(continued)
Configuring TCP/IP Parameters
The HP JetAdmin utility for UNIX (provided separately) may be used
to configure TCP/IP parameters. If you don’t have the software that
you need to configure your printer, see Step 21 for sources.
••
Usage of the bootp file for configuration parameters (the default is to
use the bootp file)
•• IP address (4 bytes)
•• Subnet mask (4 bytes)
•• Syslog server IP address (4 bytes)
•• Default gateway (4 bytes)
•• TCP connection timeout (in seconds)
To manually configure TCP/IP parameters:
1 Press [Items]. CFG TCP/IP = NO * appears.
2 Press [+]. CFG TCP/IP = YES appears.
3 Press [Select*]. CFG TCP/IP = YES * appears.
4 Press [Items] to manually configure TCP/IP parameters. BOOTP = YES
* appears.
If you keep BOOTP = YES *, then the values for the
TCP/IP parameters will be provided by the bootp file, no other TCP/IP
configuring is necessary.
5 Press [+] to change the value of the BOOTP = parameter. BOOTP = NO
appears.
6 Press [Select*] to save the selection. BOOTP = NO * appears. If you
selected BOOTP = NO *, then you will be prompted to configure each
of the TCP/IP parameters.
7 Press [Items] to continue configuring. IP BYTE 1 = <value *>
appears.
8 Press [+] until the value of the first byte of the IP address appears on
the control panel display. Note that if you press and hold [+], the value
will scroll rapidly.
9 Press [Select*] to save the value.
EN Getting Started Guide - 27
