
File Transfers
Transferring Switch Configurations
Syntax: copy tftp show-tech <ipv4 or ipv6 address> <filename> [oobm]
Copy a customized command file to the switch.
For switches that have a separate out-of-band management
port, the oobm parameter specifies that the transfer will be
through the out-of-band management interface. If this param-
eter is not specified, the transfer will be through the data
interface. The oobm parameter is not available on switches
that do not have a separate out-of-band management port.
Refer to Appendix I, “Network Out-of-Band Management” in
this guide for more information on out-of-band management.
ProCurve(config)# copy tftp show-tech 10.10.10.3 commandfile1
Figure A-10. Example of Using the copy tftp show-tech Command to Upload a
Customized Command File
Syntax: show tech custom
Executes the commands found in a custom file instead of the
hard-coded list.
Note: Exit the global config mode (if needed) before executing
show tech commands.
You can include show tech commands in the custom file, with the exception
of show tech custom. For example, you can include the command show tech all.
If no custom file is found, a message displays stating “No SHOW-TECH file
found.”
ProCurve# show tech custom
No custom file was uploaded with the copy tftp show-
No SHOW-TECH file found.
tech command
Figure A-11. Example of the show tech custom Command
A-32