Enclosure management commands 140
UPLOAD SUPPORTDUMP
• Command:
UPLOAD SUPPORTDUMP {"<url>"}
• Description:
o Uploads supportdump data to the specified URL.
o Supported protocols are FTP, TFTP, and USB.
o The URL must be formatted as: protocol://host/path/file.
o The URL syntax for IPv4 addresses is protocol://<ipv4 address>/path/file.
o The URL syntax for IPv6 addresses is protocol://[<ipv6 address>]/path/file.
o If your FTP server does not support anonymous connections, you can specify a user name and
password in the format ftp://username:password@host/path/file.
o To upload to the enclosure's connected USB drive, use the command UPLOAD SUPPORTDUMP
USB://D1/LOG1 (where D is the USB drive letter and 1 is the USB drive number). Up to four USB
drives are supported, so the number must be between 1 and 4.
• Access level/Bay level:
OA administrator
• Restriction:
You cannot use the UPLOAD SUPPORTDUMP command in FIPS Mode ON/DEBUG.
UPLOAD SYSLOG
• Command:
UPLOAD SYSLOG [<URL>]
• Description:
o Uploads the extended system log history for the current Onboard Administrator.
o Supported protocols are FTP, TFTP, and USB.
o The URL must be formatted as: protocol://host/path/file.
o The URL syntax for IPv4 addresses is protocol://<ipv4 address>/path/file.
o The URL syntax for IPv6 addresses is protocol://[<ipv6 address>]/path/file.
o If your FTP server does not support anonymous connections, you can specify a user name and
password in the format ftp://username:password@host/path/file.
• Access level/Bay level:
OA administrator, OA operator, OA user
• Restrictions:
None
