Enclosure Firmware Management commands 143
• Access level/Bay level:
OA administrator
• Restrictions:
o OFF—The server must be powered off or the Onboard Administrator cancels the operation. This
setting is the default.
o POWEROFF—The Onboard Administrator attempts to softly shut down the server. This is equivalent
to pressing the Momentary Press virtual button for the server. If server power remains on for more
than five minutes, the Onboard Administrator cancels the operation.
o FORCE—The Onboard Administrator forces an immediate hard shutdown of the server. This is
equivalent to pressing the Press and Hold virtual button for the server.
SET FIRMWARE MANAGEMENT SCHEDULE
• Command:
SET FIRMWARE MANAGEMENT SCHEDULE { <YYYY-MM-DD> <HH:MM> | NONE }
• Description:
Sets the date and time to run a scheduled update. Enclosure Firmware Management must be enabled
and a firmware management URL must be specified. Use NONE to disable scheduled firmware updates.
• Access level/Bay level:
OA administrator
• Restrictions:
None
SET FIRMWARE MANAGEMENT
BAYS_TO_INCLUDE SERVER
• Command:
SET FIRMWARE MANAGEMENT BAYS_TO_INCLUDE SERVER { ALL | <bay number> [{ , |
- } <bay number>] | NONE }
• Description:
Configures which server bays are included in the Enclosure Firmware Management policy. If bays were
included in a previous operation, then you must reselect the bays.
• Access level/Bay level:
OA administrator
• Restrictions:
o Bay ranges must be completely specified. Base bays, side a bays, and side b bays cannot be mixed
in a single range. Ranges such as 1a-4b or 5-7a are not valid. For example, the following command
designates base bays 1 through 5 only. Side a or side b bays are not included:
set firmware management bays_to_include server 1-5
Multiple ranges must be specified in the same statement, for example:
set firmware management bays_to_include server 1-4, 1a-3a, 1b-2b
