72 Removal and replacement EN
Installing memory cards (DRAM)
Note
The HP LaserJet 6L Pro does not support memory upgrades.
1 Unplug the power cord from the printer. You should not install a
memory card while the printer is in SleepMode.
2 Open the Printer Door, remove the toner cartridge, and close the
Printer Door. Protect the toner cartridge from light while you are
working on the printer.
3 Remove any paper in the paper tray. Gently tip the printer onto its
side so that the memory cover is on top as shown in Figure 3.
4 Remove the Memory Expansion Cover by carefully pulling the tab
out and away from the printer in a gentle rocking motion.
5 Align the memory card with the corner notch so it is positioned as in
Figure 4. Push it firmly into the printer
Replace the Memory Expansion Cover, set the printer upright, reinstall
the toner cartridge, reinsert paper, and reconnect to the power source.
Print a self-test page (see Chapter 3) to check that the printer
recognizes the additional memory you have added. Your Total Memory
in the “Printer Information” section will show the new MB total.
1 MB card 2 MB total
2 MB card 3 MB total
4 MB card 5 MB total
8 MB card 9 MB total
1
3
2
4
5
Service.book Page 72 Thursday, September 14, 2000 11:15 AM
