A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 38
7.
Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
8. Install the access panel ("Access panel" on page 24).
System board
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drive blanks ("Hard drive blank" on page 25).
5. Remove all hard drives ("Hard drive" on page 25).
6. Remove the cache module capacitor ("Cache module capacitor pack" on page 30).
7. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on
page 31).
8. Remove the DIMM baffle ("DIMM baffle" on page 26).
9. Remove all DIMMs ("DIMMs" on page 27).
10. Remove any mezzanine cards ("Mezzanine card" on page 29).
11. Remove the heatsink ("Heatsink" on page 31).