3.
Remove the solid-state drive connector board (2).
Reverse this procedure to install the solid-state drive connector board.
Card Reader board
NOTE: The Card Reader board spare part kit does not include the Card Reader board cable.
The Card Reader board cable is included in the Cable Kit, spare part number 672006-001.
Description Spare part number
Card Reader board 696482-001
Before removing the Card Reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33), and then remove the following components:
a. Solid-state drive connector board cable (see
Solid-state drive on page 35)
b. Card Reader board cable (see
Card Reader board cable on page 37)
c. Top cover (see
Top cover on page 40)
Component replacement procedures
45
