5.
Remove the display assembly (2).
Reverse this procedure to install the display assembly.
Power connector cable
Description Spare part number
Power connector cable 687530-001
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33), and then remove the following components:
a. Solid-state drive connector board cable (see
Solid-state drive on page 35)
b. Card Reader board cable (see
Card Reader board cable on page 37)
c. Top cover (see
Top cover on page 40)
d.
WLAN module (see
WLAN module on page 53)
e. Wireless audio module (see
Wireless audio module on page 51)
68 Chapter 4 Removal and replacement procedures
