A SERVICE OF

logo

Open as PDF
next previous
Installation
Installing the Probe
36
8. Attach the support shelf cover to the right LanProbe slot using two 0.312”
(7.93 mm) #M3 machine screws, or repeat steps 1 through 9 to install a
second LanProbe in the support shelf.
9. Insert the support shelf into the rack (or cabinet) and attach it with four clip-
on sheet metal nuts (use if required) and four 0.55” (14 mm) 10-32
POZIDRIV screws. Figure 3-12 shows the completed LanProbe, power
module, and support shelf.
10. Attach the power cord to the power module and to a power source. If this is
the second LanProbe installed in the support shelf, you can use the optional
Female-Male Power Cable (8120-1575) to attach power from one power
module to the other.
Figure 3-12: LanProbe Installed in the Rack Support Shelf