CAUTION:
Disassembling any part of the fan assembly voids the part warranty and regulatory
certifications. There are no user-serviceable ports inside the Power Supply/Fan
Assembly Unit.
Because the cooling system relies on pressurized air, do not leave any of the fan
assembly slots empty longer than two minutes while the switch is operating. If a fan
assembly fails, leave it installed in the switch until it can be replaced.
Maintain the two Power Supply/Fan assemblies in operating condition to provide
redundancy.
Table 21 lists power sup ply/fan assembly unit status LED descriptions, and required
actions.
Table 21 4/32B SAN Switch power supply/fan assembly unit status LED
LED name
LED color and
behavior
Description
Action required
No light Power supply is not receiving
powerorpowerisoff.
Verify tha t the p ower supply is on
and seated and the power cord is
connected to a functioning power
source.
Power Supply
Status
Steady green Power supply is operating
normally.
No action required.
No light
System is off, boot is not complete,
or boot failed.
Verify that the system is on and
booting is complete.
Steady green System is on and power supplies
are functioning properly.
No action required.
Steady Amber
(for more than 5
seconds)
Boot failed and system is faulty. Perform the following steps:
1.
Connect a serial cable to the
system.
2.
Reboot the system.
3.
Check the failure indicated on
the system console.
4.
Contact HP Technical Support.
System Status
Flashing amber
or green
Attention is required. A number
of variables can cause this status
including a single power supply
Check the management interface
andtheerrorlogfordetailsonthe
cause of the status. Contact HP
SAN Switch installation guide
107
