Invacare 1073955 Manual

A SERVICE OF

next previous

SECTION 5—FRONT RIGGINGS

Orbit

™

30 Part No. 1073955

SECTION 5—FRONT RIGGINGS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE:Forthisprocedure,refertoFIGURE 5.1.

Installing Front Riggings

1. Turnthefrontriggingassemblytothe

side(openfrontriggingis

perpendiculartowheelchair).

2. Installthehingeplatesonthefront

riggingassemblyontothehingepins

onthewheelchairframe.

3. Pushthefrontriggingassembly

towardstheinsideofthewheelchair

untilitlocksintoplace.

NOTE:Thefootplatewillbeontheinsideofthe

wheelchairwhenlockedinplace.

4. Repeatthisprocedurefortheother

frontriggingassembly.

5. Toreleasethefrontrigging,pushthe

frontriggingreleaseleverinward,

rotatefrontriggingoutward.

FIGURE 5.1 Installing/Removing Front

Riggings

Removing Front Riggings

1. Pushthefrontriggingreleaseleverinward

2. Rotateswingawayfrontriggingassemblyoutward.

3. Lifttheswingawayfrontriggingassemblyoffthehingepins.

Footrest

Mounting

Pin

Mounting

Tube

Footrest

NOTE:Allswingawaystylefootrestsar e

installedthesameway.Onlyonestyleof

footrestisshownforclarity