Installation Instructions (cont'd)
Installation Checklist
BEFORE LIGHTING THE PILOT:
• Check the gaslines for leaks.
a. Use a soapy water solution. DO NOT test for gas leaks
using amatch or open flame.
b. Brush the soapywater solution on all gaspipes, joints and
fittings.
c. Check for bubbling soap• This means you have a leak.
Turn OFF" gasand make the necessaryrepairs.
d. Recheckfor leaks.
e. Rinseoffsoapy solution and wipe dry.
• Isthe new temperature-pressurereliefvalveproperly installed
and piped to art adequate d_in? See _Temperatttre-Pressure
ReliefValve"section•
• Are the cold and hot water lines connected to the water
heater correctly? See "Water Piping" instructions in the
_lnstallation Instructions _ section.
• Is the water heater completdy filled with water? See "Filling"
instructions in the Installation Instructions section.
• Will a water leak damage anything? See the "Facts to
Consider About the Location" section.
• Is there proper clearance between @e water heater and any-
thing that might catch fire? See the Facts to Consider About
the Location" section.
• Do you have adequate ventilation so that the water heater
will operate propetly? See Combustion Air and Ventilation
in the _Facts to Consider About the Location" section.
'" ly ....
• Is the draft hood vent piping proper secured. See Ventmg_
instructions m the Installation Instructions section.
• Is there proper dearance betw_n the vent pipe and anything
that might catch on fire. See Venting instructions in the
"Installation Instructions" section.
HOT
GAS SUPPLY
TEE
(Sediment
trap) PIPE CAP
DRAIN VALVE '
VENT PIPE TO
OUTDOORS
OR CHIMNEY
DRAFT HOOD
SHUTOFF VALVE
• Is the vent pipe properly sloped and does the vent terminate
outdoors? See "Venting" instructions in the "Installation
Instruct ons seCtiOn.
• Do you need to call your gascompany to check the gaspipe
and itshookup?
UNION
SHUTOFF VALVE
COLD
PRESSURE
REUEF VALVE
(Do not rap or plug)
i
6" AIR GAP
FLOORDRAIN
MODEL RATING PLATE
16
