84 DNX7220
Tone Setup
You can set a Tone curve.
1 Display the Tone screen
See <Equalizer Control> (page 83).
2 Set the Tone
1
2
3
4
5
6
7
8
9
1 Tone curve becomes flat.
2 Bass adjustment items are displayed.
3 Middle adjustment items are displayed.
4 Treble adjustment items are displayed.
5 Sets the Center frequency.
6 Sets the level.
7 Sets the Q factor. (Only Bass and Middle can
be set)
8 Bass DC Extend settings. (Only when Bass is
selected)
If turned "On", it extends the bass
center frequency to the low register by
approximately 20%.
9 Returns to the "Equalizer" screen.
Audio Control
Zone Control
You can set the front and rear audio source.
1 Display Zone Control
Touch
in the "Audio
Control Menu" screen (page 82).
1
2
1 Displays the current source.
2 Returns to the "Audio Control Menu" screen.
2 Set the Zone Control
3
5
5
6
7
4
3 Turns the Zone Function (that sets different
source sounds for front and rear speakers)
On or Off.
4 Switches the front and rear audio sources.
(This button appears when the Zone
function is On.)
Use "Reverse" to change over the front and
rear audio sources.
5 Sets the front and rear audio source
separately.
(This button appears when the Zone
function is On.)
⁄
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is also
switched to the same source.
6 Adjusts the volume of the rear channel.
(This button appears when the Zone
function is On.)
7 Returns to the "Audio Control Menu" screen.
