A SERVICE OF

logo

Open as PDF
next previous
8484 85
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
Crossover network setup
Youcansetacrossoverfrequencyof
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X’over].
X’over screen appears.
3
Set each item as follows.
Phase*
Setsthephaseofsubwooferoutput.
Thephaseisreversed180degreeswhensetto
“Reverse”.
HPF FREQ
HighPassFilteradjustment.(Whenfrontorrear
speakerisselectedonSpeakerSelectscreen)
LPF FREQ
LowPassFilteradjustment.(Whensubwoofer
isselectedonSpeakerSelectscreen)
Slope
Setsacrossoverslope.
*Thisfunctionisavailableinthespecific
situation.
Onlywhen“Subwoofer”is
settootherthan“None”in“SpeakerSetup”.
Onlywhen“Subwoofer”issetto
“ON”in“SpeakerSetup”and“LPFFREQ”is
settootherthan“Through”.
WhenSpeakernetworkissetto3way
(DNX7310BT/DDX7031BT):
Range switching area (graph)
Selectsthebandforsettinggain,frequency
filter,andslope.
TouchtheleftarctosettheLPF,thecenterarc
tosettheBPF,andtherightarctosettheHPF.
Phase*
Setsthephaseoftweeter,midrange,and
wooferoutput.
Thephaseisreversed180degreeswhensetto
“Reverse”.
Gain
Setsgainofeachspeaker.
HPF FREQ
HighPassFilteradjustment.(Whentweeteris
selectedonSpeakerSelectscreen)
BPF FREQ
BandPassFilteradjustment.(Whenmidrange
speakerisselectedonSpeakerSelectscreen)
LPF FREQ
LowPassFilteradjustment.(Whenwooferis
selectedonSpeakerSelectscreen)
Slope
Setsacrossoverslope.
*Onlywhen“Subwoofer”issetto“ON”in
“SpeakerSetup”.
NOTE
•Forhowtoswitchtothe3-wayspeakersystem,
see
3 way speaker system setup (P.32)
intheQuickStartGuide.Connecting3-way
speakerswiththe2-waymodeselectedcanbreak
thespeakers.
Car type setup
Youcansetupthecartypeandspeaker
network,etc.
1
Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.
2
Select your car type from the list.
NOTE
•Ifyourcartypeisselected,theDelayTime
Alignmentissetautomatically(fortiming
adjustmentofsoundoutputforeachchannel)to
havethehighestsurroundeffects.
Speaker location setup
1
In the Car Type screen, touch
[Location].
Speaker Location screen appears.
2
Select the speaker locations using
[3].
Front Speaker
Selectthelocationfrom“Door”/“OnDash”/
“UnderDash”.
Rear Speaker
Selectthelocationfrom“Door”/“RearDeck”,
“2ndRow”/“3rdRow”(Minivan,Minivan
(Long)).
WhenSpeakernetworkissetto3way
(DNX7310BT/DDX7031BT):
Mid Range
Selectthelocationfrom“Door”/“OnDash”/
“UnderDash”.