A SERVICE OF

logo

8888 89
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
Equalizer Control
Youcanadjustequalizerbyselectingthe
optimizedsettingforeachcategory.
Ifyouuse
,youcanalsoadjust
equalizermanually.
1
Touch [Equalizer].
Equalizer screen appears.
operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].
NOTE
•[iPod]isavailableonlyduringiPodsource.
Controlling equalizer manually
Thissettingcannotbeperformedwhenyou
select[iPod]intheEqualizerscreen.
1
Touch [EQ] in the Equalizer screen.
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (light green boxed area)
Adjustthegainlevelbytouchingtheeach
frequencybar.
Touching[2],[3],[5]and[]canalso
adjustthelevel.Use[2]and[3]toselecta
frequency,and[5]and[]tosetthelevel.
EQ INIT
Returnstothepreviouslevelwhichthegain
levelisadjusted.
Flat
Tonecurvebecomesflat.
Bass EXT (Bass Extend Settings)
Whenturnedon,thefrequencylowerthan
62.5Hzissettothesamegainlevelas62.5Hz.
Loudness
When turned on, low and high tones are
enhanced.
Highway Sound
Boostsacertainrangeofsoundthatbecomes
hardtohearduetoroadnoise.SeeHighway
sound setting (P.89).
SW Level
Adjuststhesubwoofervolume.Thissettingis
notavailablewhensubwooferissetto“None”.
SeeSpeaker setup (P.82).
Highway sound setting
Youcanboostacertainrangeofsoundthat
becomeshardtohearduetoroadnoise.
1
Touch [Highway Sound] in the Graphic
Equalizer screen.
Highway Sound screen appears.
2
Select the boost level from among
[High], [Low], and [OFF].
operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
and [User] using [2] and [3].
Controlling SystemQ-Ex
Selectsitemstobeadjustedfortonecurve
setup.Ifyouturnoffthissetting,onlyLevel
canbesetupfortonecurves.
1
Touch [ON] or [OFF] of [SystemQ-Ex].
Controlling equalizer manually
1
Touch [Tone] in the Equalizer screen.
2
Set each item as follows.
FREQ
Adjuststhecenterfrequencyforeachrange.
Settingvaluesareasfollows.
Bass:40Hz/50Hz/60Hz/70Hz/80Hz/100Hz/120
Hz/150Hz(Defaultis“100Hz”.)
Middle:500Hz/1kHz/1.5kHz/2kHz(Defaultis
“1kHz”.)
Treble:10kHz/12.5kHz/15kHz/17.5kHz(Default
is“12.5kHz”.)
LEVEL
Adjuststhelevelofeachrange.
Eachsettingvalueiswithin-8dBand8dBand
defaultis“0dB”.
Q Factor
AdjustQvalueforbassandmiddle.
Settingvaluesareasfollows.
Bass:1/1.25/1.5/2(Defaultis“1”.)
Middle:1/2(Defaultis“1”.)
Bass DC EXT
TurnsBassDCEXTonoroff.Defaultis“OFF”.
Ifyouselect“ON”,thebasscenterfrequencyis
extendedtothelowregisterbyapproximately
20%.
[Flat]
Tonelevelbecomes0(flat).
Subwoofer Level
Adjuststhesubwoofervolume.Thissettingis
notavailablewhensubwooferissetto“OFF”.
SeeSpeaker setup (P.82).