A SERVICE OF

logo

DSM250 User’s Manual
Page 128 Revision 1.4.16a
6.16 Maretron IPG100 Configuration
This describes the configuration of the Maretron IPG100 firmware version 1.0.0. The DSM250 is
capable of configuring settings for the Internet Protocol Gateway (IPG100). A screenshot of the
IPG100 configuration menus is shown in Figure 128 below.
Figure 128 – IPG100 Configuration Screen
6.16.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 129 – IPG100 Advanced Configuration Screen
6.16.1.1 Device Instance
Program this parameter to the desired instance number for this device. You can program this
parameter to any value between 0 and 252. The default device instance is 0.