33
Speaker Setup
Adjust each speaker’s relative volume balance so that the volumes of
all speakers’ test tones sound equal at the listening position.
Initial setting is 0 dB for all speakers.
1 Press SETUP for more than 3 seconds.
The test tone is played back from the front Left speaker.
Adjust the MASTER VOLUME so that it is slightly loud and
fix it there.
2 Press LEVEL +/– to control the speaker level.
The speakers will be switched as follows in intervals of about
2 seconds.
Adjust the volume with the LEVEL +/– buttons while the
indicator is flashing so that the volume from all speakers
except the subwoofer (SW) appears the same. Level
adjustments possible in the range from –10 dB to +10 dB.
After all speakers have been adjusted, operate the Delay time
setting (see page 34).
Notes
• As the subwoofer (SW) has a special playback band, normal
adjustment is not possible with the test tone. Please adjust the
subwoofer while listening to actual music (see page 35).
• Make sure you adjust the test tone volume by Test Tone before
playing back discs.
Adjusting Each Speaker’s Relative
Volume Balance - Test Tone
LEVEL +/–
SETUP
→ L → C → R → RS → LS
EN00_L-MS30.book Page 33 Tuesday, September 2, 2003 4:19 PM
