Network Problem Solving Problem Solving
125
• Did you select the DP-C106 as the
current Printer?
Before printing, you must select the
DP-C106 as the current Printer from
your Windows computer, Mac OS
computer, or UNIX workstation.
• Make sure that the Printer is
switched On.
Someone may have turned the
Printer Off, or the Automatic Power-
Off or Power Saver mode function
may have engaged.
• If you are printing over an IPX
(Novell) network, verify through the
PCONSOLE utility that the job was
sent to the Novell queue and that the
queue is being used by the Printer.
• Ensure that the job does not contain
a PostScript error.
Check with the operator, or use Fiery
WebSpooler to check the job status.
A job containing a PostScript error
appears in red.
To obtain information on the
PostScript error, make sure the Print
to PS Error option is set to Yes in
Printer Setup.
Jobs sent to the parallel port do
not print.
• Ask the administrator to increase the
parallel Port Timeout in Seconds
on the Printer Control Panel.
• Ask the administrator to change the
Ignore EOF Character setting on the
Printer Control Panel.
If you are printing in ASCII format
PostScript only, set Ignore EOF
Character to No; if you are printing in
Binary format PostScript, set it to
Yes.
• If you print using the DOS copy
command, make sure to use the /b
option when printing binary files.
