Wired rear loudspeakers
When no wireless RF surround sound is possible or when there
is too much interference you can still enjoy Dolby Pro Logic II
and Dolby Digital surround sound by connecting the wireless
receiver box to the TV with a stereo cinch to stereo 3.5 mm
jack cable.
& Connect the (not supplied) cable to the AUDIO IN (TV)
connector 4 at the wireless receiver box and the R and L
surround outputs at the back of the TV.
é Select Off in the Wireless surround menu item of the Setup,
Speakers menu, p. 9.
28
Side connections Camera or Camcorder
& Connect your camera or camcorder as shown.
é Connect to VIDEO 2 and AUDIO L 3 for mono
equipment. For stereo equipment also connect
AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input
1 and
audio inputs 3.
Do not connect cable 1 and 2 at the same time.This may cause
picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The
headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust the
headphone volume.
®
AUDIO inAUDIO in
(TV)(TV)
2.2.8V RMS8V RMS
AUDIO in
(TV)
2.8V RMS
13V DC inV DC in13V DC in
LR
4 /15W
4 /15W
LR
4 /15W
1 22
1
2 3
41
23
4
33
44
SURROUND
Connect extra subwoofer
To enhance the sound reproduction of your TV you can connect
an externally powered subwoofer (between 20 and 250 Hz).
& Connect the audio cable of the external subwoofer to the
SUBW. socket at the back of your TV.
é Select External in the Setup, Speakers menu, Subwoofer, p. 9.
For details, please refer to the subwoofer’s manual.
2214.2 gb 18-09-2003 14:07 Pagina 28
