FEATURE MENU CONTROLS (CONTINUED)
A
uto-Programming (see
previous page) adds all the
channels it can find (on your
Antenna or Cable TV system) into
the TV's memory. Add/Delete
Channels makes it easy for you to
add other channels, or drop
unwanted channels, from the list of
channels in the TV's memory.
Select CHANNEL MEMORY
(ADD/DELETE CHANNELS)
control.
With the FEATURES MENU on
screen, move the RED highlight
with the MENU (M) buttons.
Then press the MENU button.
Press the CHANNEL ▲▼ or
number buttons to select the
channel you want to add or delete.
Press the MENU ᮣ button to
ADD the channel into the TV's
memory.
Press the MENU ᮤ button to
DELETE the channel from
memory.
Repeat steps 2 and 3 for each
channel you wish to add or delete.
Press the STATUS or MENU
button to clear the screen when
through.
ADD/DELETE CHANNELS
SMART HELP
Remember. You can also
add the AUX 1 VIDEO,
AUX 2 VIDEO, AUX 1 Y PB PR,
or SIDE VIDEO modes just like a
channel. Then by pressing the
CHANNEL ▲▼ buttons the
AUX(iliary) mode can quickly be
selected to use the desired set of
Input jacks (see page 33).
Note: AUX(iliary) VIDEO modes
are located between the lowest
and highest channel numbers
within the ADD/DELETE
CHANNEL control screen.
NOTE: A separate ADD/DELETE CHANNEL memory
may also be created for the ANT(enna) B Input on the
rear of the set (if an Antenna or Cable TV signal has been
connected). Just press the button on the remote,
while in the ADD/DELETE CHANNEL mode, to switch
between the ANT A and ANT B channel memory lists.
Then follow steps 2 and 3 as shown to the left to add or
delete the desired channels.
