ᴾ
ᴾ
Using the XDJ-AERO as the VirtualDJ Pro 7
controller/audio output device
ᴾ
Installing the driver software
Install this unit’s driver software onto the computer from the CD-ROM included with this unit.
For installation instructions, see “Installing the driver software” in the XDJ-AERO’s operating instructions.
Connecting this unit and the computer
With this unit’s power turned on, connect this unit and the computer using a USB cable.
VirtualDJ Pro 7 settings
1 Open the Settings screen.
ᴾ
2 Make the audio output routing setting.
1
Click [Sound Setup].
2
Select as shown below from the [Sound card:] pull-down menu.
ᴾ
3
Select as shown below from the [Outputs:] pull-down menu.
To use this unit’s mixer section to mix the sound:
To mix the sound internally in VirtualDJ Pro 7:
3 Set up the options.
1
Click the [Options] tab.
2
Click [Tooltips] and select [Disable].
ᴾ
Launch VirtualDJ Pro 7, then click the [CONFIG] icon.
