SERVICE AND ADJUSTMENTS
REPLACING BATTERY (See Figs. 25 and 26)
WASHERS
R.AINING
"'"Q\ I\ llc* *. l l
SOUARE KEY (RF.N_ ......._-'
WHEEL ONLY) "'"-
RG. 23
wristwatch bands, rings, etc.
TO START ENGINE WITH A WEAK BAI"rERY
(See Fig. 24)
I_ AUTION: Leed-edd batteries ganerato [
explosive gases. Keep sparks, flame
and smoking materials away from bat-
t_ Aivea_weareye l_vdNm
around batteries.
If your battery istoo weak to start the engine, it should be
recharged. (See "BATTERY" in the Customer Responsibili-
ties section of this manual).
If "jumper cables" are used for emergency starting, follow
thisprocedure:
IMPORTANT: YOUR TRACTOR IS EOUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cat:detothe POSITIVE (+)
terminal ofeach battery, takingcare notto shortagainst
chassis.
• Connect oneend of the BLACKcable tothe NEGATIVE
(-) terminal of fully charged battery.
• Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fueltank and battery.
TO REMOVE CABLES, REVERSE ORDER -
• BLACK cable first from chassis and then from the fully
charged battery.
• RED cable last from both batteries.
POSITIVE TERMINAL
TERMINAL
POSITIVE
TERMINAL
BATTERY
• Lift seat pan to raisedposition.
• Disconnect BLACK battery cable firstthen RED battery
cable and carefully remove battery from tractor.
• Install newbattery withterminals insame positionas old
battery.
• Firstconnect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown, Tighten securely.
Slide terminal cover over terminal.
• Connect BLACK groundingcable tonegative(-)terminal
with remaining hex bolt and keps nut.Tighten securely.
SEAT PAN
FIG. 25
TERMINAL COVER KEPS
NUT
HEX
PosmvE NEGATIVE
(RED) CABLE (BLACK) CABLE
FIG. 26
RG. 24
21
