ASSEMBLY
HOW TO SET UP YOUR TRACTOR
CHECK BA'B'ERY (See Fig. 2)
• Lift seat pan to raised position.
• If this battery is put into service alter month and year
indicated on label (label located between terminals)
charge battery foeminimum of one hourat 6-10 amps.
(See "BATTERY" inCustomer Responsibilities,s_'tJon
of this manual for charging inst--).
SEAT PAN
LABEL
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjus_nent boll
• Remove adjustment bait. lock washer and fiat washer
securing seat to cardboard pac_ and set aside for
assembly of seat to tractor.
• Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
• Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
• Push down on seat to engage shoulder bolt in,slotand
pull seat towards rear of tram'tot.
• Pivot seat and pan forward and assemble adjustment
bolt, Iockwasher and flatwasher loosely.Do nottighten
• Lower seat into operating position and s_ton seat.
• Slide seat untila comfortable position isreached which
allows you to pressclutctVbrakepedal all the way down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt securely.
SHOULDER
BOLT
FLAT WASHER
LOCK WASHERs,
ADJUSTMENT
BOLT
FIG. 3
NOTE: YOU may now rollor drive your tractor offthe skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
7
