12
Memory Tuning
For easy selection, you can store the
frequencies of your favorite stations in
memory. You can store up to 18 SW
and 18 FM frequencies, and up to 9
frequencies in each of the other bands.
Follow these steps to store a frequen-
cy into memory.
1. Use direct-access or manual tun-
ing to tune to the frequency you
want to store.
2. Press
M
.
3. While
M
flashes, enter a memory
location code using the numeric
keypad. For SW and FM bands,
select from 1–9 and 01–09. For
other bands, select from 1–9. The
frequency is stored,
M
stops flash-
ing, and the display shows the
memory location code
Note:
If you wait more than 15 sec-
onds to press a memory location code
number,
M
stops flashing and you must
begin again at Step 2.
To select a stored frequency, press
FM
,
MW
,
LW
, or
SW
to select the band.
Then enter the memory location code.
ADJUSTING THE
ANTENNA
For the best reception, adjust the tele-
scoping antenna for the band you want
to listen to.
FM
— Fully extend the antenna and
rotate it for the best reception.
LW
and MW (AM)
— Rotate the re-
ceiver. The receiver uses the internal
antenna for the LW and MW (AM)
bands.
20-219.fm Page 12 Wednesday, August 4, 1999 9:23 AM
