Manual-3
4 3 21
FILTERSALL
+
-
ACN 001 345 482
100-240V
50/60 Hz 20 WATTS
DEQ 60L
MADE IN U.S.A.
RANE CORP.
FOR CONTINUED
GROUNDING
PROTECTION
DO NOT REMOVE
SCREW
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
+
-
+
-
+
-
+
-
+
-
+
-
+
-
WIRING
TIP / PIN 2 = POSITIVE
RING / PIN 3 = NEGATIVE
SLEEVE = SIGNAL GROUND
PIN 1 = CHASSIS GROUND
OUTPUT B
BYPASS
OUTPUT A INPUT B INPUT A
U.S. and International Patents Pending
1 Channel A and B INPUTS: Plug the outputs of the mixer or other source to these Inputs. Choose between the XLR, the ¼" TRS,
or the Euroblock Input jack—use only one—they do not sum.
Rane adheres to the international and U.S. standard for balanced pin congurations: Pin 1 is chassis ground (neutral), pin 2 is hot
(positive), and pin 3 is signal return (negative).
Avoid the temptation to use unbalanced tip-sleeve ¼" TS plugs, but if you must, keep them short as possible, 10 feet (3 meters)
maximum. Long unbalanced cables invite hum, noise and other undesirables. Balanced TRS ¼" are much better at rejecting noise.
e Euroblocks normally connect the cable shield to the ground terminal. For those installations where the internal shield-to-
chassis connection causes interference, connect each shield directly to the chassis grounding screw located above each Euroblock
connector, keeping the shield wrapped around the audio conductors as much as possible. For optimum Electromagnetic
Interference (EMI) immunity, connect the shields at both ends of the cable to chassis ground.
See the RaneNote “Sound System Interconnection” for more information on system connections and proper grounding practices.
2 Channel A and B OUTPUTS: Any Output can be used simultaneously with the others, take your pick. Same wiring as above...
keep cables short, always wire balanced when possible, eat your vegetables, yadda yadda.
3 BYPASS mode switch: See 5 on the Front Panel, previous page.
4 Power connector: Uses the standard cord provided. Inside the DEQ 60L is a universal internal switching power supply that
accepts 100 to 240 VAC at 50 to 60 Hz, allowing it to work in most countries.
REAR PANEL DESCRIPTION
