12
OPERATION
TO INSTALL BITS
See Figures 10 and 11.
Unplug your drill.
WARNING:
Failure to unplug your drill could result in acciden-
tal starting causing serious injury.
Open or close the chuck jaws to a point where the
opening is slightly larger than the drill bit you intend
to use. Also, raise the front of your drill slightly to keep
the drill bit from falling out of the chuck jaws.
Insert drill bit into chuck the full length of the jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as
shown in figure 7. This could cause drill bit to be
thrown from your drill resulting in possible serious
personal injury or damage to your chuck.
Tighten the chuck jaws on drill bit.
To tighten: grasp the chuck collar and rotate it to the
right. Release the chuck collar and then turn the chuck
body to the left.
Note: Rotate the chuck body in the direction of the
arrow marked GRIP to tighten chuck jaws.
Do not use a wrench to tighten or loosen the chuck
jaws.
TO REMOVE BITS
Unplug your drill.
WARNING:
Failure to unplug your drill could result in acci-
dental starting causing serious injury.
Loosen the chuck jaws from drill bit.
To loosen: grasp the chuck collar and rotate it to the left.
Release the chuck collar and then turn the chuck body
to the right.
Note: Rotate the chuck body in the direction of the
arrow marked RELEASE to loosen chuck jaws.
Do not use a wrench to tighten or loosen the chuck
jaws.
Remove drill bit from chuck jaws.
RIGHT
Fig. 10
WRONG
Fig. 11
DRILL BIT
CHUCK JAWS
CHUCK
BODY
CHUCK
COLLAR
RELEASE
(UNLOCK)
GRIP
(TIGHTEN)
