Changing the light bulb
(on some models)
Electrical Shock Hazard
Before removing the light bulb, either turn
Temperature Control to OFF and unplug
the freezer, or disconnect the electricity
leading to the freezer at the main power
supply.
Shock and injury can occur if electricity
remains connected.
To replace interior light:
1. Disconnect freezer from power supply,
and turn Temperature Control to OFF.
NOTE: Turning Temperature Control to
OFF does not disconnect power to
the freezer.
2. Remove the light shield by squeezing
sides slightly and pulling out.
3. Replace bulb with 15watt appliance bulb
4. Replace light shield. Insert back tabs into
slots and squeeze shield slightly to insert
front tabs into slots.
5. Reconnect freezer to power supply and
refer to “Setting the temperature control”
on page 8.
II
Light shield
Using the key eject lock
(on some models)
If your freezer is equipped with a lock, it can
help reduce the hazard of child entrapment.
To lock or unlock the freezer, you must
hold the key in the lock while turning. The
lock is spring loaded, so the key cannot be
left in the lock.
If the key is lost, contact your Roper
dealer for a replacement. Always give the
complete model and serial number of your
freezer when requesting a replacement key.
11
