Chapter 11 Telnet
EOC350 Series User’s Guide
67
swqosq [-t <strict/wfq/mix>]
[-p <0/1>]
Display or setup the QoS Queue Scheduling, and
802.1p or IP Priority scheme selection.
• -t: schedule mode
• strict: strict priority
• wfq: weighted fair queue Q3/Q2/Q1/Q0
service weight 8/4/2/1
• mix: Q3 is strict, Q2/Q1/Q0 service
weight=4/2/1
• -p: select QoS scheme
• 0: base on 802.1p (default)
• 1: base on IP TOS/TC or DSCP
swqosrate Display or setup bandwidth throttling on LAN1/
LAN2.
• <lan1/lan2>: configure LAN1 or LAN2 port
• <tx/rx>: direction, incoming (rx) or outgoing
(tx)
• <on/off>: enable or disable control on this
direction
• <N>: the maximum rate (multiply value by
64kbps). Range from 1 to 3125, bandwidth
control is invalid if N >= 3125 (>200Mbps)
swqostc Display or setup the QoS configuration for TCP/
UDP traffic classification, to assign a higher priority
for up to 8 different TCP/UDP protocols.
• <set>: rule set index (0~2)
•
<act/deact>: activate or deactivate this set
•
<port>: TCP/UDP port number (0~65535),
• <queue>: select queue index (0~3) for this
rule set to q0 (lowest priority) / q1 / q2 / q3
(highest priority)
swsmac [-m <mac>]
[-c <lan1/lan2/off/del>]
Display or setup the static MAC entry. A total of 8
entries can be setup.
•<mac>: max 8 entries
• <lan1/lan2>: bind the current MAC entry to
LAN1 or LAN2 port, i.e. enable this MAC entry
as static MAC
• <off>:disable this MAC entry, neither bind to
LAN1 nor LAN2
• <del>: remove the current MAC entry.
Invalidate this MAC entry to the default 00-00-
00-00-00-00
Table 50 Generic Telnet Commands (continued)
COMMANDS
ARGUMENTS
[ ] IS OPTIONAL
DESCRIPTION
