Filter
Top Products
(11)
USING THE PK-6000: GENERAL
First Use of the PK-6000
e rst time you use this device, ensure that you have installed fully charged batteries.
Hold down the power button for several seconds to start the device. To calibrate the
Stylus for continued use, enter “Menu Settings” and select “Screen Calibration.” You will
be taken through several steps as shown below to click the touchscreen with the Stylus
to ensure its correct operation. Important: Do not power o before completing the
calibration or you will have to repeat the steps. If you upgrade rmware or reset your PK-
6000 to its original factory settings, you will have to perform the calibration again.
e text on the rst two calibration screens advise you to “Please check the cross carefully” with the
Stylus. e nal screen reads “Adjust OK” after you have successfully clicked your way through.