Filter
Top Products
15
Storing effects programs
After you’ve created a configuration that you like, you can store it for future recall. To store
your changes, press the
VALUE
knob and then turn the knob to select a store location.
Press the
VALUE
knob again to store the program.
Copying effects programs from one location to another
Copying programs is easy. Just call up the program that you want to copy. Then, press the
VALUE
knob, twist it until you find the location where you want to store your copy, and
press
VALUE
again to store the program in its new location.
Restoring factory defaults for the effect settings
Once you have saved changes to a preset program, you can still recall the original settings.
To enter the RESTORE FACTORY PRESETS mode, simply hold down the
VALUE
knob
as you turn the unit on and then select the program to be restored (or AL for all programs).
Press the
VALUE
knob to confirm your selection. The display will blink rapidly several
times to indicate the restore was successful. Any program changes you have made will be
lost, so you might want to copy the program to another location first.
To exit the RESTORE FACTORY PRESETS mode, just turn the
EFFECTS
knob. You
can also turn the X Guitar off and then on again, without holding down any knobs or
buttons, to exit the RESTORE FACTORY PRESETS mode.
Deferred program change
In normal operation, the X Guitar switches immediately to the program you select.
However, in some situations — especially when playing live — you may want the ability to
scroll through program numbers while remaining in the current program setting. For
example, if you’ve got a clean and chorusy rhythm sound stored in program A3, and you
want to switch next to a bright lead sound stored in program C5, you don’t want to have to
hear all the programs in between. In these cases, use the X Guitar’s Deferred Program
Change mode.
While turning on the X Guitar, hold down either one of the
Program Up
or
Program
Down
buttons. Letters will scroll by on the display, spelling the word “deferred.”
In this mode, you can scroll through program numbers without having the program change
each time. When you arrive at a program you want to use, press the
Program Up
and
Program Down
buttons or both pedals at the same time in order to switch to that program.
To exit Deferred Program Change mode, turn the X Guitar off, and then turn it back on
again without holding down any buttons.