Filter
Top Products
3
Front Controls
The front of the guitar combines traditional controls with two special switches for the built-
in effects.
1.
Pickup Selector Switch
– The five-position switch selects one of the following pickup
combinations:
1-Bridge only. 2-Bridge + Middle. 3-Middle only. 4-Middle + Neck. 5-Neck only.
All three pickups are humbucking models, which greatly reduce noise relative to non-
humbucking pickups. The bridge-position pickup has the traditional side-by-side
humbucker configuration. The middle- and neck-position pickups use a “stacked single-
coil” configuration.
2.
Volume Knob
- This knob attenuates (lowers) the output from the X Guitar’s pickups.
It is independent of the effects and acts before them.
3.
Program Up/Down Switch
– Increment or decrement the effect program using this
switch.
4.
Effects On/Off Switch
– Flip this to the upward position to turn on the effects. Be
sure to turn it off after playing to conserve the batteries.
5.
Output Jack
– For stereo output, plug a TRS cable into this
jack to connect the guitar to a mixer or recording device. (You
may need to use “Y” cables or a special breakout cord.)
Plug in a TS (mono) cable to connect to a guitar amplifier.
Plug in a pair of headphones for private performance.