Filter
Top Products
MULTI-TASKER™
400-0343-003
10
10
4. [?CnUi]
This command will return general information
about the card and its status. It is a function of
both the card and the front panel and is only
available with Multi-Tasker™ Front Panel
systems that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command
[VER] from the Terminal Window. The system
will respond with feedback similar to the
following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
The MT109-102 is in slot #4. Send the
command [?C4] to receive the feedback status.
Each status field begins with a '+' and ends with
the card slot number (ex: C04). The feedback
will be similar to the following:
[+MT109-102C04+VR690-0133-008C04
+VO16C04+VI161616C04+VB08C04+VT08C0
4+VL01C04+VM0C04]
MT109-102 = Card Type
VR690-0133-008 = Firmware version
VO16 = Output Volume Level=16
VI161616 = Input volume levels
VB08 = Bass level = 08 out of 16
VT08 = Treble level = 08 out of 16
VL01 = Loudness (00=ON, 01=OFF)
VM0 = Mute (0=OFF, 1=ON)
The Input Volume status line is read from left to
right as outputs one through three. Each
volume level is 2 digits, in this case, each is set
to 16.
5. [?Ui]
This command will return general information
about the Multi-Tasker™ and cards installed in
the unit.
Command Format: [?Ui]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
A Multi-Tasker™ with ID #0 has a front panel
with part number MT101-102 and contains an
MT109-102. Send the command [?] and receive
the following feedback:
[+MT101-102U0+MT109-102C04]
MT101-102U1 = Panel Number and Unit ID
MT109-102C04 = An MT109-102 is in slot 4.
6. [STA]
This command enables/disables automatic
feedback from the front panel. The command
affects any card with auto-feedback capability,
not just the MT109-102. The default at power
on or reset is STA0, OFF.
Command Format [STA1] = ON
Command Format [STA0] = OFF
Feedback Prefix Definitions:
+VR = Firmware Version
+VO = Output Volume
+VI = Input Volume
+VB = Bass Volume
+VT = Treble Control
+VL = Loudness Control
+VM = Mute Control
Example:
Command = [VLOA12C04]
Feedback = [+VO12C04]
+VO = Output Volume
12 = Output volume level12
C04 = Card slot number